Loading ...
Loading ...
Loading ...
nsta ation instructions
Door and hinge remova[
Some installations require door removal to get the refrigerator to its final location.
Tools needed:
Phillips screwdriver
%" (9.5 ram) hex head driver
Electdc Shock Hazard
Disconnect power to refrigerator before removing doors° Connect power
only after replacing doors°
Green ground wire must be attached to top hinge while performing door
remova_ and replacement,
Failure to do so may result in death, e_ectric shock, fire, or injury to persons°
To avoid property damag6 observe the fol#owing:
Protect vinyl or other flooring with cardboard, rugs or other protective material prior to moving
the refrigerator,
Tape decorative paneh #ehct modds) securdy in place before removing door handtes,
Do not adjust the refrigerator to be any shorter than 68½" (I 740 ram) taft (minus hinge and cap).
Doing so may damage underside componen%.
'I
2
Unplug power cord from power source.
Remove toe grille (see page 8).
o Open both doors 180':',or as wide as possible.
Note: for refrigerators in operation, shut off water before removing water line from the door.
To disconnect the water line:
Push in white collar ( a ) and hold.
Pull the dooFside tube from the connector ( b ).
To reconnect the water line:
Firmly push tube _46"(8 ram) into the connector.
Use lines on the tube as a guide for full insertion.
If tube end is damaged, cut off _AG"(8 ram) before
reconnecting.
If leaking occurs, cut and reconnect the line.
Step 2
b
Loading ...
Loading ...
Loading ...