0.01m User Manual

Loading ...

Press

Pull

Installation Tips

How to Use the Quick-Connect Fittings

To connect:

Note: There is an existing mark at the end of the tubing for you to conrm if the

tubing is fully inserted into the tting.

• Push the tubing into the tting until you reach the mark on the tubing.

Note: If the tubing is not fully inserted, no seal will be created, and leakage will

occur.

• When the tubing is fully inserted, put the blue lock clip on the tting. It will lock

the tubing in place and prevent it from falling off.

To disconnect:

• Remove the blue lock clip from the

tting;

• Use your thumb and index nger

to press down on the lock sleeve.

Use your other hand to pull out the

tubing from the tting (Figure 2).

Note: Please do not pull out the

tubing directly, or else it will damage

the tting and cause leakage.

Figure 1

Figure 2

Note: If the tubing is too long,

cut it to a suitable length with a

sharp utility knife or scissors. Cut

the tubing squarely and cleanly

(Figure 1). Make sure the tubing

is fully inserted.

Mark for

Full Insert

Cut Cleanly

and Squarely

Loading ...

User Manual - Page 9