Loading ...
Loading ...
Loading ...
13
• The installation sequence of lters shall not be reversed to avoid affecting the
normal function of the system.
• If you do not use the system for a long time (more than 1 week), it is
recommended to turn on the faucet to ush for a while before using it again.
• If the system is not used for a long time, please disconnect the water supply and
remove the batteries.
• Please replace the lter regularly according to the lter life indicator.
Note: While the testing was performed under standard laboratory conditions,
actual performance may vary depending on the source water quality and
water usage. In case of a premature blockage and failure of the lters, it is
recommended to replace the lter in accordance with actual usage.
• Clean the system with clear water. Do not spray the water directly onto the lter.
Do not use steel wool, an abrasive cleaner or a corrosive liquid such as gasoline
or acetone.
• When cleaning, do not pour other liquids into the lter or you risk damaging the
lter system.
• Check the system and water pipe ttings regularly for water leakage to avoid
any property damages.
• If using well water as the source, please make sure the feed water has been
through a pre-ltration system, otherwise, large particles in well water will clog
the lter easily and shorten lter life.
System Maintenance
• Less water ows out.
a. Please check the lter life indicator. If the lter has expired, replace it
immediately.
b. The water inlet pressure is abnormal. The normal water inlet pressure is 14.5-87psi.
Please check the water inlet pressure and use the lter after the pressure is normal.
If the water inlet pressure is too low for a long period of time, install a booster pump
before use. If the pressure is too high, the ultra ltration membrane will be damaged.
The pressure regulator should be installed before use.
c. The water inlet and outlet valves are not fully opened. Please check the
cold water valve, feed water adapter, and faucet to ensure that they are fully
opened.
d. The lter is blocked. If the water quality is poor, the lter may become blocked
after being used for a certain period of time. It will need to be replaced. If using
well water as the source, please make sure the feed water has been through
a pre-ltration system, otherwise, large particles in well water will clog the lter
easily and shorten lter life.
e. The inlet water tubing or outlet water tubing is bent. Please check and
straighten out the inlet and outlet water tubing.
Troubleshooting
Loading ...
Loading ...
Loading ...