Loading ...
Loading ...
Loading ...
12. Adjust the tool rest approximately 1/8" away from
the corners of the wood and 1/8" above the center
line. Note the angled position of the tool rest base.
WARNING: For your own safety, after adjusting
• tool rest be sure and lock the tool rest holder,
e tool rest slide and the tool rest.
Look at the speed chart. Notice that a 2" square
turning up to 18" long should run at 875 R.P.M. for
"roughing." Move the Poly-V-Belt on the pulleys to
the slowest speed as outlined under "Changing
Speeds" section.
When finish-turning any size wood, notice that the
recommended speed of the lathe is increased con-
siderably above the rough-turning speed.
However, if excessive vibration occurs at any speed
always shut the lathe off immediately and reduce
the speed until the vibration is not excessive.
During any spindle turning operation check all locks
frequently for tightness. Also frequently check the
fit of the cup center against the turning. Do not
allow the wearing away of wood to cause a loose fit.
WARNING: To avoid injury from thrown pieces,
turn workplece by hand to make sure it doesn't
hit any parts of the lathe. Always make sure the
workpiece is properly mounted and the lathe Is
set at the proper speed (RPM) before re-inserting
the switch key. Never spindle turn workpieces
longer than these specified in the chart for the
sizes shown. Never spindle turn workpieces
greater than 4" square.
\
TOOL REST
WOOD
LINE
==-'2
d._ =._
FACEPLATE TURNING
e II=i[_];,I_I::(,-_,.tli={olll_l/l_[l'll
1z, ] =__4"MAX 875 1350 /
I0 1 ,"MAX 1350 2250
5" 1 4"MAX 1350 2250
0" 1 4"MAX ..... 2'250 3450
SPINDLE TURNING
1" l t2" 1350 3450
2" 1 18" 875 2250
3" 27" 875 2250
4" J 36" 875 2250 i
FACEPLATE TURNING
WARNING: When doing faceplate turnings, always
follow instructions supplied with the faceplate for
mounting the workpiece to the faceplate. (for one
(1) possible exception--see "special note" to the
right) workpieces not properly and securely
attached to the faceplate may come loose during
operation, fly off, and hit the operator (fsceplates
aresold separately at SearHee the list of recom-
mended accessories for the correct part numbers.)
SPECIAL NOTE: The instructions with your faceplate
may tell you to remove the 3/4-16 hex nut from the
spindle before installing your faoeplate. Instead of re-
moving the 3/4-16 hex nut, tighten the faceplate up
against the nut on Modet 113.228360 Wood Lathe.
3/4-16 NUT
For information on how to do faceplate turning, refer to
the "Power Tool Know How" books available at your
Sears store, (See the list of recommended accessories
for the correct part number.)
Faceplates are attached to this wood lathe byscrewing
them onto the threaded section of headstock spindle and
up against the 3/4-16 hex nut as shown in the diagram,
Donot remove the 3/4-16 hex nut from the spindle when
mounting faceplates to the spindle on this model wood
lathe.
/
SPINDLE
FACEPLATE
27
Loading ...
Loading ...
Loading ...