Loading ...
Loading ...
Loading ...
STRAIGHT
EDGE
,\
12. Hold straight edge tightly against bed sections. Lift
up on bed sections until air gap between straight
edge and bed sections disappears. The edge of
straight edge will now be touching bed section
along full length of straight edge. (See illustration.)
If bolts that hold bed sections together have been
properly tightened, the bed sections will remain in
this position. If bed sections will not stay in this
position, tighten bolts in center of bed a little more
and complete Step 11 over again.
STRAIGHT ADJUSTMENT
EDGE
X
/
BED
f_, l', 1!, ]
BED
AFTER
ADJUSTMENT
13. While you hold the bed sections in this position
tighten bolts that hold center bed mounting bracket
to the bed sections, The lathe bed should now be
straight and level. Use straight edge to make sure
bed sectfons did not move during bolt tightening.
14. Tighten all five nuts under workbench to secure
lathe to workbench,
BED
STRAIGHT
EDGE
,\
ILLUSTRATION SHOWS
REAR OF LATHE
t3
Loading ...
Loading ...
Loading ...