Loading ...
Loading ...
Loading ...
11.Fromtheloosepartslocatea#6 x3/8phillipshead
screw(seeillustration).Usinga #2 phillips head
screwdriver install this motor cover stop screw, it is
located on backside of headstock as shown in illust-
ration.
WARNING: the motor cover stop screw is for your
protection, it prevents the motor cover from slid-
ing back too far when moving belt for speed
changes, it protects you from touching heated
motor after lathe use. it must be reinstalled.
MOTOR
COVER
MOTOR
COVER
STOP SCREW
#6 x 318 PAN HEAD SCREW
BED
#2 PHILLIPS
HEAD .-""
SCREWDRIVER
ui ii i .| i i,,m i i i i iiii i i iii
INSTALLATION OF CUP AND SPUR
CENTERS
1, Finda 3/4-16 hex nutamong the loose parts and
screw itontoheadstock spindle until finger tight,
SPINDLE
i i
3/4-16 HEX NUT
tD-O_
--I =..
O
_=
ill i
CENTER POINT
ill
CUP CENTER
/
D
2. Find two center points, a spur center, and a cup
center among the loose parts. To inserta point into
a center, hold the center agatnst workbench as
i_Lustrated.Check and be sure that inside of open-
ing at the end of center is clean. Place a point into
opening and using a small board, gently tap the
point into the center.
Repeat this process on the other pointand center.
i i ii i i . illl i,iil,lll
i i •
;i i,!; R,CENTERi:i'! _ :i_Li_,:
CENTER POINT
Loading ...
Loading ...
Loading ...