Loading ...
Loading ...
Loading ...
TO CHANGE BLADE DEPT_
See Figure 20.
The blade depth should be set so that the outer points cff
tile blade are higher than the workpiece by approximately
1/8 in. to 1/4 in. but the lowest pmnts {gullets) are below
the top surface.
B Push the bevel Iockin$ lever to tqe left for elevahon
triode.
{3 Raise the blade by turning the height/bevel adiusting
handwheel counterclockwise or lower it by turning [ne
handwheel clockwise
GULLET
F,g 20
TO CHANGE BLADE ANGLE
See Figu_e21.
Push the bevel locking lever to the left for angle mode.
B To angle the blade, pus/_ the helght,'bevel adjusting
hand-wheer into the cabinet, to engage bevel gear. and
turn the handwheel until the bevel indicator shows the
correct angle.
_] Return the bevel locking lever secure}y to the right to
lock the angle, while holding the heighVbevet adjusting
handwheel in place,
BLADE
BEVEL
INDICATOR
BEVEl
NEIGHTiBEVEL LOCKINGLEVEII
A£JL]STIN6ltAl4DWliEEL
Fig. 21
CHECKING SLIDING MITER TABLE AND
tVIA_(ING ADJUSTMENTS
TO POSITION THE SLIDING MITER TABLE
See Figures 22- 23
A slide bolt is located on the front of the sew between the
saw tab e and the front sos e. When the arrows on botlh
_hesin, table and stlding table are a_lgreo, rnls bolt s|ides
throu )r the holes in both tables leck_ng mem into a fi×eG
oosition.
The sltdlng table has three positions providing eddJtional
front suooort when working with larger workpieces. At-
ways lock the sliding table when not in use.
To unlock1be sliding miteT table:
a Ld{ the tab on the slide bolt and move the bog to the
tar left
B LOCKthe be t into position by pushing the tab oown
and into I!_e far left hand notcn
To rock the sliding miter table:
Lift the tab and elide the bolt through L_otntables
D LOCkthe bolt into position by pushing the tab down
and rite the notch.
NOTE: When moving t!le miler Dash. _eel. hands and
Bngers out of areas where thev may oe _[nched. Pull the
m_[er base into sosition with fingers extended and ti$1ng
only your thumL as shown in figure 23
[
I
SLOTSFOB LOOKING;
IVIITERTABLE
Fi_lli!22
.... ! :
:: • : ;: ... : •
23
Loading ...
Loading ...
Loading ...