Loading ...
Loading ...
Loading ...
TOOPEN/CLOSE(SET-UP/TEAR DOWN) THE
LEG STAND
See Figure 7.
To open (set-up} tt_e leg stand:
m Step l:Withthe saw table on endand standing totheside,
use your left hand to pull the _egstand latch towards you.
13 Sten 2: Once the leg stand is released from the table
saw base, ease the legs of tl_e sland down.
S±e__.3_:Grasp the upper legsupport below the saw
cabinet. Ste_: Keeping your left hand clear of the leg
stand, pull the leg stand up until it locks into place.
Steo 5:Wth the left hand firmly on the table tilt handle,
grasp the leg stand with your right hand.
B _s 6and 7:Pushthe legstand towardsthe groundwith
your right hand and pu]! in Ihe same direction with your
leit hand until the table saw is in an upright position.
To close (tear down) the leg stand:.
81 Ste_: Standing to the side ot the table saw, grasp
the table tilt tlandle with your left hand. Ste_ 2: Tilt the
table saw to your left and grab the leg just below the
leveling foot.
E] _.e.l;L_:Lower the saw to the floor until it is balanced
on end.
Sto,04_:Using your left hand, release the leg stand
latch.
m _s 5 and 6: Once the leg sland is released from the
fable saw base, ease the legs of the leg stand toward
the floor.
i_ St__p7: Lift the lower leg of the leg stand until it locks in
place.
TO SECURE/LEVEl-THE SAW
With the leg stand open and the table saw resting on a
flat, level surface= the saw should not move or rock from
side to side. It the saw rocks from side to side, the leveling
foot needs adjusting until the leg stand is balanced.
e Turning clockwise will lower the foot.
8 Turning counterclockwise will raise the foot.
16
_ 7
TEAR DOWN
7
I
Loading ...
Loading ...
Loading ...