Loading ...
Loading ...
Loading ...
tools needed
NOTE: AII fasteners are metric except arbor screw and
mounting hardware for lower guard,
Tools required for assembly and alignment of miter
saw:
• #2 Phillips Screwdriver
• Combination Square
• Adjustable Wrench
_,_ #2 PHILLIPS SCREWDRIVER
COMBINATION SQUARE ADJUSTABLE WRENCH
COMBINATION SQUARE MUST BE TRUE
DRAW LIGHT
LINE ON BOARD
ALONG TRIS EDG_.__
SHOULD BE NO GAP OR OVERLAP WHEN
SQUARE IS FLIPPED OVER IN DOTTED PO61TION
STRAIGHT EDGEOF
BOARD 3/4" THICK
THIS EDGE MUST BE
PERFECTLYSTRAIGHT
FURNISHED WRENCH I12" ARBOR BOX
AND 12mm OPEN END
knowing your slide compound miter saw
I Warning labels.
2 Handle Latch--The miter saw can be locked in the
lowered position for compact storage.
3 Depth Adjustment bolt--When properly adjusted it
limits saw blade travel to approximately 1/4" below
the table.
4. Miter Lock Handle--The miter lock handle clamps
the miter saw at a desired miter angle. Index points
have been provided at 0.15, 22-1/2, 30, 45 L/R.
5 Bevel Lock Handle_The bevel lock handle locks
the saw at a desired bevel angle.
6 Bevel Adjustment Stops--Bolts that are adjusted to
stop sawblade at 90_ bevel and 45; bevel.
7. Carriage Lock Knob--Lock the carriage in place.
8. Lower Blade Guard-The blade guard helps pro-
tect your hands from the blade in the raised posi-
ticn. To avoid binding on the workpiece, it retracts
as the blade is lowered.
10. Cover Plate
Screw
9. Saw Handle--The saw handle contains the trigger
switch with a lock-off button. The blade is bowered
into the workpiece by pushing down on the handle.
The saw will return to its upright position when the
handle is released.
!0. Cover Plate Screw--When tightened, holds cover
plate in place and can be loosened to let cover
plate swing back for blade changing.
9. Saw Handle
1. Warning Labels
3. Depth Adjustment bolt
with Knurled Nut
and Jam Nuts
6. Bevel Adju
Stops
2. Handle Latch
7, Carriage
Lock Knob
8. Lower Blade
Guard
4_Miter Lock Handle
5. Bevel Lock
Handle
Loading ...
Loading ...
Loading ...