Loading ...
Loading ...
Loading ...
TROUBLE SHOOTING GUIDE - ELECTRICAL
PROBABLE CAUSE SUGGESTED CORRECTIVE ACTION
1 Brushes not seated
or Iightly sticking
PROBLEM
Brake does not stop
blade within
3-6 seconds.
2.
3.
4
Motor brake winding--
overheated from use of not
recommended accessory
or rapid on/off cycling.
Arbor screw loose
Other
Motor does not start. 1. Fuse.
2. Brushes worn.
3 Other
Brush sparking when 1 Normal--automatic brake
switch released working properly.
=- Inspect/clean'replace brushes
(see maintenance section)
i Install new brushes
-- Use a recommended blade
Let cool down,
-- Retighten
-- Authorized service: See "'Brake Trouble Shooting
page 24.
-- 15-Amp time delay fuse, or circuit breaker
-- See "Maintenance page 22
-- Authorized service
TROUBLE SHOOTING GUIDE - GENERAL
PROBLEM PROBABLE CAUSE SUGGESTED CORRECTIVE ACTION
Blade hits table 1. Adjustment of depth stop. -- See 'Depth Stop", Step 7 page 11
Angle of cut 1. Misaiignment. -- See "Assembly and Alignment" page 9-11
not accurate
Cant adjust 1. Center bolt too tight. -- Adjust
miter angles
2, Lubrication dried up. -- Clean and re lubricate between table and
base. See "Maintenance Section"
Power-head See "Assembly and Alignment", Step 6, page 11.
won't fully rise.
-- See 'Maintenance."
-- Get authorized Sears Service
Blade binds, jams, -- See 'Basic Saw Operation' page 16.
burns wood.
Tool vibrates or
shakes.
1 Pivot misadjustment.
2, Lubrication dried up
3. Pivot spring not replaced
properly after service.
1 Improper operation.
2. Dull blade.
3. Improper blade.
4. Warped blade.
1. Saw blade not round
2, Saw blade damaged.
3 Saw blade loose
4. Other
Replace or sharpen blade
-- Replace with 8-1 4" diameter blade designed
for the materiaI being cut.
Replace blade.
-- Replace blade.
-- Replace blade.
-- Tighten arbor screw
Get authorized Sears Service.
23
Loading ...
Loading ...
Loading ...