Loading ...
Loading ...
Loading ...
– 15 –
9. OPERATION & USE
9.2 STARTING AND STOPPING –
FIG.4
Make sure the power is on.
Starting:
– Slide the red button (F) upward and hold to
unlock the switch cover.
– Lift up the switch cover to release the
emergency stop switch. The green light (G) will
come on.
– Turn the speed dial (H) clockwise to start the
motor.
Note: If the amber light (I) is lit. This indicates
the protection circuit is active preventing the
motor from starting.
This occurs when the power supply was
interupted while the machine was still running.
It is designed to prevent accident and injuries
caused by the machine unintentionally
restarting.
To reset the amber light, turn the speed dial
anti-clockwise until it clicks.
The amber light will go out and the machine can
be started normally.
Note: If no lights appear remove the plug from
the power supply before checking the glass
fuse (J) is installed and still intact.
Stopping:
– In an emergency striking the switch cover (F)
will operate the stop button.
Note: Under normal conditions turn the speed
dial (H) anti-clockwise until it clicks.
When leaving the machine unattended, push
the stop button cover closed and remove the
plug from the power supply.
Warning! Before attempting adjustment, servicing or
maintenance, remove the plug from the power supply.
9.3 HEADSTOCK ANGLE ADJUSTMENT –
FIG.5
The headstock angle indicator can be used as a guide;
however, to make sure exact angle is set, an engineers
protractor is recommended.
– Support the headstock to prevent it falling.
– With the 36mm spanner (K) loosen nut (L).
– Adjust the headstock to desired angle.
– Fully tighten nut (L).
FIG.4
FIG.5
(I)
(H)
(G)
(J)
(F)
(L)
(K)
Loading ...
Loading ...
Loading ...