Loading ...
Loading ...
Loading ...
8
ASSEMBLY
3. Place the flat washer and belleville washer over the steering wheel and
secure with the hex screw. See Figure 3.
Steering Wheel Cover
Hex Screw
Steering Wheel
Steering Wheel
Column
Belleville Washer
Figure 3
4. Place the steering wheel cover over the center of the steering wheel and
push downward until it “clicks” into place.
Install Operator’s Seat
To install the seat proceed as follows:
NOTE: The seat is shipped with the seat switch and seat pan attached. A
second person may be needed to hold the seat.
1. Cut any straps securing the seat assembly to the riding mower. Remove any
packing material.
NOTE: Be careful not to cut the wiring harness connecting the seat and the
seat switch in the bottom of the seat.
2. Remove the two shoulder screws and flange lock nuts in the seat pan as
shown in Figure 4.
Shoulder Screws
Flange Lock Nuts
Figure 4
3. Rotate the seat into position and secure the seat into place with the
previously removed shoulder screws and flange lock nuts. Be careful not to
crimp or damage the wire harness while installing the seat. See Figure 5.
Shoulder Screws
Flange Lock Nuts
Figure 5
NOTE: Be sure to push the excess wire from the wire harness into the seat
box hole before continuing.
Lower Deck Discharge Chute Deflector
WARNING
Never operate the mower deck without the chute deflector installed and
in the down position.
NOTE: For models with a 50” deck skip ahead to step 6.
1. Remove the keys that are attached with a zip tie to the chute bracket.
2. Remove the flange lock nut and hex screw from the deck.
3. Place the chute deflector on the deck, be sure to insert the tabs on the chute
deflector into the holes on the deck. See Figure 6.
3
4
5
5
4
Figure 6
Loading ...
Loading ...
Loading ...