Loading ...
Loading ...
Loading ...
Installation Instructions
17
B
2.
ATTACH THE MOUNTING PLATE
A
ttach the plate to the wall using toggle bolts. At least
one wood screw must be used to attach
the plate to a wall stud.
1.Remove the t
oggle wings from the bolts.
2.
Insert the bolts into the mounting plate through
the holes designated to go into drywall and
reattach the toggle wings to ¾ " onto each bolt.
To use toggle bolts:
3.Place the mounting plate against the wall and
insert the toggle wings into the holes in the wall to
m
ount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careful to avoid pinching fingers
between the back of the mounting plate and the wall.
4.Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
B
3.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole
large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
B
4.
ADAPTING MICROWAVE BLOWER
F
OR OUTSIDE BACK EXHAUST
1.Remove and save screw that holds blower motor
to micro
wave,Lift up the blower plate.
2.
Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjus
t the
blower unit.
W
all
Bolt End
Toggle Wings
Toggle
Bolt
Spacing for Toggles More
Than Wall Thickness
Mounting
Plate
B
ack of
Microwave
Blower Motor
Screw
Blower Motor
BEFORE: Fan Blade
Openings Facing Front
screw
Loading ...
Loading ...
Loading ...