Loading ...
Loading ...
Loading ...
Installation Instructions
13
A2.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws, a
hole large enough for the power cord to fit through,
and a cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
A3.
ADAPTING MICROWAVE BLOWER
FOR RECIRCULATION
2
Back o
f
Microwave
1.Remove and save
screw that holds
blower plate to
microwave.
Scr
ew
Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
3.Roll the blower unit 90° so that
fan
blade
openings
are facing out the up of the
microwave.
Place the blower unit back into the opening.
CAUTION: Do not pull or stretch the blower unit
wiring. Make sure the wires are not
pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of microwave
oven.
Secure the blower unit to the microwave with the
screw from Step 1.
6.Replace the blower plate in the same position as
before with the screw.
AFTER: Fan Blade
Openings Facing UP
Back of
Microwave
Blower Motor
Screw
Blower Plate
.
5
.
4.
Loading ...
Loading ...
Loading ...