Loading ...
Loading ...
Loading ...
iNSTALLiNG STACKED WASHER/DRYER
Remove Transport System
NOTE: Slide washer/dryer onto cardboard or hardboard before
moving to avoid damaging floor covering.
Excessive Weight Hazard
Use two or more people to move and install washer/dryer,
Failure to do so can result in back or other injury.
I M PORTANT: Position the washer/dryer so that the rear of the
washer is within approximately 3 ft. (900 mm) of its final location.
There are 4 shipping bolts in the rear panel of the washer that
support the suspension system during transportation. These bolts
also retain the power cord inside the washer until the bolts are
removed.
1. Keep the washer/dryer in the upright position while removing
the shipping bolts.
2. Using a 1/2" (13 mm) wrench, loosen each of the bolts.
4. Close the bolt holes with the 4 transport bolt hole plugs.
IMPORTANT: If the washer/dryer is to be transported, call your
product distributor or installer. To avoid suspension and structural
damage, your washer/dryer must be properly set up for relocation
by a trained professional.
J
3. Once the bolt is loose, move it to the center of the hole
and completely pull out the bolt, including the plastic spacer
covering the bolt. Once all 4 bolts are removed, discard the
bolts and spacers.
16
Loading ...
Loading ...
Loading ...