Loading ...
Loading ...
Loading ...
Operating the Dishwasher en-us
39
Wash cycle end
The wash cycle has ended when the
display 8 reads ‹:‹‹.
If the signal tone has been set, the
wash cycle end is also indicated by a
buzzer.
To change the signal volume:
1.
Open the door.
2.
Press the On/Off button (.
3.
Hold down function key # and
press Start button P until the
display 8 shows •:‹x or š:‹x
(x can be any number).
4.
Release both buttons. The LED for
function key # flashes and the
digital display shows the factory
setting.
5.
Press function key # until the
display shows ›:‹ƒ.
6.
Press function key 3. Each time
the button is pressed the set
value increases by one level;
when it reaches the value ›:‹„,
the display jumps back to ›:‹‹
(off).
7.
Press Start button P to save
the setting.
Auto power off
This setting determines the length of
time the control panel stays
illuminated after the cycle is
complete.
To save energy the recommended
setting is ˜:‹‚.
This setting can be adjusted from
˜:‹‹ to ˜:‹ƒ.
To change the setting:
1.
Open the door.
2.
Press On/Off button (.
3.
Hold down function key # and
press Start button P until the
display 8 shows •:‹x or š:‹x
(x can be any number).
4.
Release both buttons.
The indicator of function key #
flashes and the display 8
shows the factory set value.
5.
Press function key # until the
display 8 indicates ˜:‹x.
6.
Press function key 3 until the
display corresponds with your
requirements.
7.
Press Start button P.
Switching off the appliance
Short time after the end of the wash
cycle:
1.
Open the door.
2.
Switch off On/Off button (.
3.
Turn off water supply.
4.
Remove the utensils when they
have cooled down.
›:‹‹ Off
›:‹‚ low
›:‹ƒ medium
›:‹„ loud
˜:‹‹ dishwasher does not turn off
automatically
˜:‹‚ dishwasher turns off
automatically after 1 minute
˜:‹ƒ dishwasher turns off
automatically after
120 minutes (2 hours)
Loading ...
Loading ...
Loading ...