Loading ...
Loading ...
Loading ...
!
Fig. AA
MITERING (FIG. BB)
This sawing operation is the same as crosscutting except
the miter gauge is locked at an angle other than 90° .
1. Hold the workpiece firmly against the miter gauge.
2. Feed the workpiece slowly into the blade to prevent
the workpiece from moving.
Fig. BB
3
i Fig. CC
DADO CUTS (FIG. DD)
1. The dado table insert is included with tills saw.
Remove saw blade, blade guard, installed dado,
and dado table insert.
2. Instructions for operating the dado are packed with the
separately purchased dado set.
3. The arbor (1) on this saw restricts the maximum width
of the cut to 1/2 inch.
4. It is not necessary to install the outside flange (2)
before screwing on the arbor nut (3). Make sure
that the arbor nut (3) is tight, and that at least one
thread of the arbor sticks out past the nut.
5. Use only the 6 inch dado set and keep the
width 1/2 inch or less. It will be necessary to remove
the blade guard and splitter when using dado. Use
caution when dado is operating.
6. Use only the correct number of round outside
blades and inside chippers as shown in the dado
set's instruction manual. Blade or chipper must not
exceed 1/2".
7. Check saw to ensure that the dado will not strike
the housing, insert, or motor when in operation.
For your own safety, always replace the blade, blade
guard assembly, and blade insert when you are finished
with the dado operation.
USING WOOD FACING ON THE RIP FENCE
(FIG. CC)
When performing some special cutting operations, add a
wood facing (1) to either side of the rip fence (2):
1. Use a smooth straight 3/4 inch thick wood board (1)
that is as long as the rip fence.
2. Attach the wood facing to the fence with wood screws
(3) through the holes in the fence.
A wood fence should be used when ripping material such
as thin paneling to prevent the material from catching
between the bottom of the fence and the table.
Fig. DD
ioll
J
J
\
\
,'2
\3
Page 19
Loading ...
Loading ...
Loading ...