Loading ...
Loading ...
Loading ...
MITER GAUGE ADJUSTMENT (FIG, O)
1. Make sure thatthe mitergauge willslide freely
through bothtable grooves.
2. Loosen the lock knob(1). Set pointer(2) at the 90°
mark on the scale.
3. Using a piece of scrap wood, make a 90° cut. Then
check the cut piece to see if itwas cutat 90°. If not
90°,continue to adjust the miter gauge body (3) until
the wood piece is cut at 90°.
4. When a 90° degree cut has been made, loosen the
pointer screw (4) and set on the 90° scale mark.
Tighten screw.
Fig. O
3. Lock the fence handle (2).The fence should be
parallel with the miter gauge groove.
4. If adjustment is needed to make the fence parallel
to the groove, do the following:
5. Loosen the two screws (3) and lift up on the handle (2).
6. Hold the fence bracket (4) firmly against the front of
the saw table. Move the far end of the fence until it
is parallel with the miter gauge groove.
7. Tighten both screws (3) and push the handle (2)
to lock.
8. If fence is loose when the handle is in the locked
(downward) position, do the following.
9. Move the handle (2) upward and turn the adjusting
screw (5) clockwise until the rear clamp is snug.
Do not turn the adjusting screw (5) more than
1/4 turn at a lime.
10. Over-tightening the adjusting screw (5) will cause
the fence to come out of alignment.
90°
8 6 7 5
2 m
Fig. P
x___x_ ',__ x__
-- 11\
RIP FENCE ADJUSTMENT (FIG. P)
To avoid injury from an accidental start, make sure the
switch is in the "OFF" position and the plug is not
connected to the power source outlet.
1. The fence (1) is moved by lifting up on the handle (2)
and sliding the fence to the desired location. Pushing
down on the handle (2) locks the fence in position.
2. Position the fence on the right side of the table, and
along one edge of the miter gauge grooves.
RIP FENCE INDICATOR ADJUSTMENT (FIG. P)
1. The rip fence indicator (6) points to the
measurement scale (8). The scale shows the
distance from the side of the fence to the nearest
side of the blade.
2. Measure the actual distance with a rule. If there is a
difference between the measurement and the
indicator, adjust the indicator (6).
3. Loosen the screw (7) and slide indicator (6) to the
correc! measurement scale. Tighten screw and
remeasure with the rule.
.,_ : Page 13
Loading ...
Loading ...
Loading ...