Loading ...
Loading ...
Loading ...
Feature Overview
OVEN SUPPORTS& OVENVENTS
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
Oven Vent Location
The oven is vented under
upper control panel for
the upper oven and
between the doors for the
lower oven. When the oven
is on, warm air is released
through the vent. This
venting is necessary for
proper air circulation in the
oven and good baking
results.
OvenVent
Installing Oven Rack Supports
ALWAYS INSTALL OVEN RACK
SUPPOR T BEFORE TURNING ON
THE OVEN (WHEN THE OVEN IS
COOL).
To install oven rack support, insert
the supports by pushing them downward
into the two brackets on each side of
the oven interior, as shown below.
To remove the oven rack support for
a self-clean cycle, pull up the support to
disengage them from the brackets. If
the rack supports are not removed, the
self-clean cycle won't start.
Removing and Replacing
Extendable Oven Racks ALWAYS
ARRANGE OVEN RACKS WHEN THE
OVEN IS COOL (PRIOR TO
OPERA TING THE OVEN). Always use
oven mitts when using the oven.
To remove an oven rack, pull the rack
forward. Lift up the rack offthe oven rack
slider. To install an oven rack, locate
the two pinholes in the small plates at
the front corners of the rack. Place the
rack on the side sliders and drop the pin
holes over the pins on the sliders.
Installed on sliders
>
To remove from
sliders
Pull oven rack forward and lift
it up off the oven rack slider. To place on sliders
Do not try to install the extendable oven racks
into the standard oven rack levels (or rack support).
Installing Standard Oven Rack ALWA YS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO
OPERA TING THE OVEN). Always use oven mitts when using the oven.
To install, take standard oven rack with the handle in front of you and the stoppers looking down. Align the rear of the
rack on the level you want to install it, then push on the rack to slide it in the level until it stops.
upward
This stopper will prevent the rack to bump on This "safety stopper" will stop the rack when you pull it out.
the convection fan cover at the end of its course. This will prevent you to accidentally pull the rack too far and
make it fall.
Do not try to install the standard oven rack on the sliders.
Loading ...
Loading ...
Loading ...