Loading ...
Loading ...
Loading ...
Rinnai Australia 13 Operation Manual
WIRELESS WATER CONTROLLERS
WIRELESS WATER CONTROLLERS BATTERIES
Wireless water controllers use 2 x
1.5V AAA batteries. The battery
symbol in the display monitor
indicates the remaining charge in
one of three levels.
To replace the batteries:
Before attempting to change the batteries first ensure that all moisture has been removed from the
water controller. Failure to do so may allow water to enter the water controller causing damage.
1. Remove the controller from the wall mounting bracket.
2. To open the battery compartment turn the battery compartment cover a full turn anti-clockwise.
3. Insert the batteries observing the correct polarity as shown on the rear of the controller.
4. To close the battery compartment align the " " and " " marks on the battery compartment
cover and the controller body. Then turn the battery compartment cover a full turn clockwise to
obtain the correct seal.
5. Return the controller to the wall mounting bracket.
Use only 2 x 1.5V AAA alkaline batteries.
DO NOT
• mix old and new batteries.
• use different types of batteries at the same time.
• heat or expose to flame.
• take apart or short circuit.
• attempt to recharge alkaline batteries.
• use batteries if their covering has been damaged or peeled off.
Battery life is approximately 1 year.
• Dispose of used batteries according to the manufacturers instructions.
Remove batteries if the water controller is not going to be used for a long period. This
will help avoid damage from leaking batteries.
Battery charge level OK.
Battery charge level is low.
Batteries need replacing (when flashing)
1 532 4
Insert batteries observing
the correct polarity as
indicated inside the
battery compartment
Turn battery
compartment
cover one full turn
anti-clockwise
to open
Align marks and
turn battery
compartment
cover one full turn
clockwise to
close
IMPORTANT
Loading ...
Loading ...
Loading ...