Loading ...
Loading ...
Loading ...
General Cleaning
continued)
The door is heavy. For]
safe, temporary storage, lay the doorI
fiat with the inside of the door facingI
down. /
To Remove and Replace Oven Door
TO Remove Oven Door:
1. Open the door.
2. Remove screws located on the inside of the oven door near the hinges A
(one on each side.)
3. Close the door to the quarter-open position. Grasp the door firmly on both
sides and lift up and offthe hinges.
4. To clean oven door, follow the instructions provided in the cleaning chart
under General Cleaning
Lift d_ stnlight off 2 door hinges
Figure 2
To Replace Oven Door:
1. Be surethe hinge arms are in the quarter-open position. Becareful if pulling
the hinges open by hand. The hinges may snap back against the oven frame
and could pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms into slots at
the bottom of the door.
3. Hinge arms must go into the range slots evenly. The hinge arms should be
inserted into the bottom corners of the door as far as they can go.
4. If the door isnot in line with the oven frame, remove it and repeat the above
steps.
To Remove and Replace Warmer Drawer (if equipped)
To Remove Warmer Drawer:
1. _ Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. On the right glide you will find a shield attached with a hex-head screw (see
figure 1). Using a 1/4" socket and ratchet remove the shield.
4. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever.
5. Pull the drawer away from the range.
To Replace Warmer Drawer:
1. Replaceshield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassisglide (seefigure 2).
3. Alignthe glideon eachsideofthe drawer with the glide slotsonthe range.
4. Pushthe drawer into the rangeuntil levers"click" (approximately 2"). Pull
the drawer open again to seat bearing glides into position. If you do not
hear the levers "click" or the bearing glides do not feel seated remove
the drawer and repeat steps 2-4. Thiswill minimize possibledamage to
the bearing glides.
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
16
Loading ...
Loading ...
Loading ...