Loading ...
Loading ...
Loading ...
21
Adjustments
Introduction
Withouta properly installed safetyreversal system, persons (particularly small children) could be
SERIOUSLY INJUREDor KILLED by a closing garage door.
l
Incorrect adjustment ofgarage door travel limits will interfere with proper operation of
safetyreversal system.
l
After ANY adjustments are made, the safetyreversal system MUST be tested.Door MUST
reverse on contact with 1-1/2" (3.8 cm) high object(or 2x4 laid flat) on floor.
To preventdamage to vehicles, be sure fully open door provides adequate clearance.
Your garage door opener isdesigned with electronic controlsto make setup and adjustments easy.The
adjustments allow you to program where the door will stop in the open (UP) and close (DOWN) position.
The electronic controls sense the amountofforce required to open and close the door.The force is
adjusted automatically when you program the travel.
NOTE: If anything interferes with the door’s upward travel it will stop. If anything interferes with the door’s
downward travel, it will reverse.
UP (Open)
DOWN (Close)
PROGRAMMING BUTTONS
The programming buttons are located on the leftside panel of the garage door opener and are used to
program the travel.While programming, the UP and DOWNbuttons can be used to move the door as
needed.
UP Button
Adjustment
Button
DOWN Button
PROGRAMMING BUTTONS
To watch a short instructional video on programming your new garage door opener use your
smartphone to read the QR Code below:
Loading ...
Loading ...
Loading ...