Loading ...
Loading ...
Loading ...
17
Install the Protector System
®
OPTION C
FLOOR INSTALLATION
Use an extension bracket(not provided) or wood block to raise the sensor bracket if needed.
1. Carefully measure the position of both sensor brackets so they will be the same distance from
the wall and unobstructed.
2. Attach the sensor brackets to the floor using concrete anchors(notprovided).
3. Slide the carriage boltinto the sloton each sensor.
4. Insert the boltthrough the hole in the sensor bracketand attach with the wing nut. The lens on
both sensors should point toward each other. Make sure the lensis not obstructed by the
sensor bracket.
I
nsid
e
G
arage
Wa
l
l
(Not provided)
1 2
Carriage Bolt
1/4"-20x1/2"
Wing Nut
1/4"-20
3
4
2 Wire the Safety Reversing Sensors
PRE-WIRED INSTALLATIONS: If your garage alreadyhaswires installed for the safetyreversing
sensors, see page 18.
HARDWARE
Insulated Staple
(Not shown)
OPTION A
INSTALLATION WITHOUT PRE-WIRING
1. Run the wire from both sensors to the garage door opener. Attach the wire to the wall and
ceiling with the staples.
2. Strip 7/16 inch (11 mm) ofinsulation from each setof wires.Separate the wires. Twist the white
wires together. Twistthe white/black wires together.
3. Insert the white wires into the white terminal on the garage door opener. Insert the white/black
wires into the grey terminal on the garage door opener. To insert or remove the wires from the
terminal, push in the tab with a screwdriver tip.
1
2
3
Staple
D
RED
W
RE
7/16" (11 mm)
Loading ...
Loading ...
Loading ...