Loading ...
Loading ...
Loading ...
16
Install the Protector System
®
1 Install the Safety Reversing Sensors
HARDWARE
Carriage Bolt
1/4"-20x1/2"
Wing Nut
1/4"-20
The safetyreversing sensors can be attached to the door track,the wall, or the floor. Ifthe door track will
not support the sensor bracketa wall installation is recommended. Choose one of the following
installations.
OPTION A
DOOR TRACK INSTALLATION
1. Slide the curved armsof the sensor bracketaround the edge of the door track.Snap into place
so that the sensor bracketis flush against the track.
2. Slide the carriage boltinto the sloton each sensor.
3. Insert the boltthrough the hole in the sensor bracketand attach with the wing nut. The lenses
on both sensors should pointtoward each other. Make sure the lensis not obstructed by the
sensor bracket.
No more
than 6 inches
(15 cm)
Carriage Bolt
1/4"-20x1/2"
Wing Nut
1/4"-20
1
2
3
OPTION B
WALLINSTALLATION
If additional clearance isneeded an extension bracket(notprovided) or wood blocks can be used. Make
sure each bracket has the same amount of clearance so theywill align correctly.
1. Position the sensor bracketagainstthe wall with the curved arms facing the door. Make sure
there is enough clearance for the beam to be unobstructed.Mark holes.
2. Drill 3/16 inch pilotholes for each sensor bracketand attach the sensor brackets to the wall
using lag screws(not provided).
3. Slide the carriage boltinto the sloton each sensor.
4. Insert the boltthrough the hole in the sensor bracketand attach with the wing nut. The lenses
on both sensors should pointtoward each other. Make sure the lensis not obstructed by the
sensor bracket.
(Not provided)
No more than
6 inches (15 cm)
1
2
Inside
G
arage
Wall
(Not provided)
Lens
Carriage Bolt
1/4"-20x1/2"
Wing Nut
1/4"-20
3
4
Loading ...
Loading ...
Loading ...