Loading ...
Loading ...
Loading ...
Lighting Instructions for
Standing Pilot Models
The surface burners on these ranges have standing pilots
that must be tit initially
A UTION: Make sure the surface burner
control knobs are in the OFF position before attempting
to light the pilots
To light the pilot:
1. Raise the cooktop
2. Light both pilots with
a match
3 To avoid pilot outage,
use caution when closing
cooktop after lighting pilots
j\
4. Observe the lighted burners Compare the flames to
pictures in the Before You Call for Service section°
If any flame is unsatisfactory, call for service
NOTE: If the pilot is too high or low, you can adjust it
See the Adjust the Surface Burner Pilots If Necessary
section of the Installation Instructions
Lighting instructions for
Electronic Ignition Models
Your surface burners are lighted by electronic ignition,
eliminating the need for standing pilot lights with
constantly burning flames
In case of a power failure, you can light the surface
burners on your range with a match Hold a lighted match
to the burner, then turn the knob to the LITE position°
Use extreme caution when lighting burners this way.
Surface burners in use when an electrical power failure
occurs will continue to operate normally°
The electrode of the spark igniter is exposed When
one burner is turned to LITE, all the burners spark
Do not attempt to disassemble or clean around any
burner while another burner is on An electric shock
may result, which could cause you to knock over
hot cookwareo
Surface Burner Controls
The knobs that turn the surface burners on and off are
marked as to which burners they control.
The two knobs on the left control the left front and
left rear burners The two knobs on the right control
the right front and right rear burners
On ranges with sealed burners:
• The smaller burner (right rear position) will give
the best simmer results It offers precise cooking
performance for delicate foods, such as sauces
or foods which need to cook over low heat for
a long timer It can be turned down to a very low
simmer setting
• The right front burner is higher powered than
the others and will bring liquids to a boil quicker
(natural gas installations only)
° On some models, the burners are all the same
size and power
Before Lighting a Burner
= If drip pans are supplied with your range, they should
be used at alt times
• Make sure all grates on the range are in place before
using a burner
To Light a Surface Burner
Electronic Ignition Models:
Make sure all burners and caps are
in place.
Push the control knob in and turn it
to LITE. You will hear a little "clicking"
noise--the sound of the electric spark
igniting the burner
Standing Pilot Models:
Push the control knob in and turn it to HI position.
The burner should light within a few seconds.
After the burner ignites, turn the knob to adjust the
flame size
Flame will be almost horizontal and wilt lift slightly
away from the burner when the burner is first turned
on. A blowing sound may be heard the first few
seconds. This normal sound is due to an improved
design for injection of gas and air into the burner Put a
pan on the burner before lighting it, or adjust the flame
to match pan size as soon as it lights, and the blowing
sound will stop
Loading ...
Loading ...
Loading ...