Loading ...
Loading ...
Loading ...
4. SAWKERF(CUTEDGE)OF STOCKROUGH
-TOOTH MARKSLEFT ON EDGE OF SAW
KERF,
NOTE:This condition is commonly called "HEEL"
a, Crosscutting or Miter Cutting,
"Heeling" will tend to slide the workpiece
along the guide fence, as the cut is being
made, and make a square cut almost impos-
sible.
Refer to step 5 under Alignment Procedure
Section -"Squaring Blade to Fence."
b. Bevel Crosscutting Or Bevel Ripping.
Refer to Step 5 Under Alignment Procedure
Section Vertical Heel Adjusting
c. Using Improper Blade for Finish Cut Desired.
Use Proper Smooth Cutting Blade
..... ROUGH KERF
EDGE
, j
...... BLADE "HEELING"
---DIRECTION OF/i1 !
- ATTEMPTED DIRECTION OF
- BLADE TRAVEL LADE TRAVEL
5. WOOD BINDS, SMOKES AND MOTOR SLOWS
DOWN OR STOPS WHEN RIPPING.
a. Dull blade or warped board°
Sharpen or replace the saw blade. Do not use
severely warped material
b_ Feed rate too fast,
Slow Feed Rate
c. Saw blade heels.
Check and align as described in Alignment
Procedure Section, Step Five
d, Fence not straighL
Replace fence.
e, Carriage Assembly Loose on Arm,
Refer to adjusting carriage bearings in adjust-
ments to compensate for wear section
6, BOARD PULLS AWAY FROM FENCE WHEN
RIPPING.
ao Saw Blade has heel,
Corrective action is the same as preceding
instructions explained in paragraph c,
7. WORKPIECE STRIKES SPREADER WHEN
RIPPING.
a. Adjust spreader per instructions in Step Six
under "Adjusting Anti-Kickback Pawls and
Spreader".
8. SAW DOES NOT TRAVEL SMOOTHLY ON ARM
TRACK,
a, Dirty Track.
Clean Track, and Lubricate with Light Grease.
b. Bad Bearing,
Replace Bearing.
c. Worn Track.
Replace Track..
IN RiP POSITION
TOP VIEW WITH ARM 90 = TO THE FENCE
E
BLADE
NOT PARALLEL
WITH FENCE
HEEL TO RIGHT'. HEEL TO LEFT:
INCORRECT INCORRECT
FEEDDIRECTION
FENCE I
PARALLEL
WITH FENCE
CORRECT
c::
_m
O
OO
QJ)
L_
p-
45
Loading ...
Loading ...
Loading ...