Loading ...
Loading ...
Loading ...
ALIIGNMENT PROCEDURE
IMPORTANT: In order to obtain maximum cutting
accuracy and safety, the following six steps must be
carefully followed° Become thoroughly familiar with
these steps so that you can always maintain your
saw in proper alignment° The accuracy of each
adjustment is always dependent upon the accuracy
of the preceeding adjustment.
Be sure to align the saw in the exact sequence
described to insure proper alignment and cutting
accuracy.
After following the 6 step assembly and alignment
procedure and the Basic Saw operation section refer
to Trouble Shooting section if any difficulty is
experienced when performing any sawing operation.
STEP ONE
Adjusting Column Tube in Column Support
1• Elevate and then lower the arm.
(a) If the column binds and elevation is difficult,
loosen the four (4) bolts, with 9/16 socket and
extention, located through the holes in the
rear column support cover until movement is
smooth but firm.
(b) If column moves front to rear within the
column support, tighten the four (4) bolts,
with a 9/16 socket and extension, located
through holes in rear column support cover
until movement disappears. Elevation should
be smooth and firm, Recheck adjustments,
repeat steps (a) and (b) if necessary.
2.. Locate the four (4) plastic hole caps in loose
parts bag #532_ After all adjustments are made to
the column support insert the plastic caps in all
four holes in rear column support cover.
STEP TWO
NOTE: The following adjustment, performed proper-
ly, will result in the work table being parallel to the
arm This helps insure the blade will cut the same
depth along the entire crosscut travel.
ATTACHING AND LEVELING TABLE MOUNTING
SUPPORT CHANNELS
i. From the loose parts bag #499, locate the follow-
ing hardware:
4 - Hex Head Bolts 5/16-18 x 3/4
4 - Lockwashers 5/16
4- Flat Washers 11/32 x 7/8 x 1/16
4 - Nuts 5/16-18
2. Attach table mount support channels with the
four (4) bolts, Iockwashers, flat washers and nuts
as illustrated Position bolts in center of channel
s_ots, finger tighten to permit channels to "slip"
against the base when leveling.
TABLE MOUNTING
SUPPORT CHANNEL
SCREWS
HERE
FLAT
HEX HEAD SCREW
5/16-18 X 3/4
LOCKWASHER
NUT
TABLE MOUNTING
SUPPORT CHANNEL
MOUNT RAILS USING
THESE HOLES
FRONT
18
Loading ...
Loading ...
Loading ...