Loading ...
Loading ...
Loading ...
(b) Using a 1/8" Hex "L" wrench loosen the four
socket set screws located through access
holes on bottom side of yoke as illustrated.
(c) Rotate the yoke assembly until blade is aligned
properly.,
(d) Lock swivel lock handleand retighten the four
(4) socket set screw& Recheck for heel if heel
condition exists, return to step (b) and repeat.
NOTE: This alignment procedure will simultaneously
set both yoke indexing positions for blade in and out
rip
NOTE: tt may be necessary to use
pliers to grip the short end of the
Hex "L" wrench to loosen or tighten
the socket cap screws° Remember
to wear eye protection when per-
forming this procedure,
FENCE FENCE
SQUARE _ SQUARE
j RIGHT
FENCE
U WRONG
(
Bevel Heel Adjustment
This adjustment helps avoid the grabbing or throwing
of the wood during edging operations,
1oWith sawblade in 90 ° crosscut position, elevate
saw, then rotate motor to its vertical position
(blade parallel to table top)., Lock bevel lock
handle and be sure swivel lock handle is in
locked position_
2,,Check blade for bevel heel by positioning square
perpendicular to fence and between blade and
table as shown. Lower arm until face of blade
rests on square, Be sure square is resting on face
of blade and not on a "set-out" tooth as this will
result in a false measurement,
3 If there is a visible gap between saw blade face
and the edge of the square, a bevel heel condition
exists and t_hefollowing adjustment is necessary.
a. Unlock the bevel lock handle and loosen the
two cap screws located thru the rear of the
motor support (see illustration). A 1/8" hex "L"
wrench is needed to loosen these screws..
b. Lift or lower the rear of the motor support until
the gap between the blade and square dis-
appears., Lock the bevel lock handles
c. Tighten the two cap screws and recheck
alignment between the face of the blade and
the square. If a gap condition exists, repeat the
above adjustment.
d. From loose parts bag #532 find the motor
support cap and install into rear of motor
support,
NOTE: It may be necessary to use
pliers to grip the short end of the
Hex"L" wrench to loosen or tighten
the socket cap screws. Remember
to wear eye protection when per-
forming this procedure,
SQUARE
TABLE
WRONG WRONG
23
7= E
,==:
Loading ...
Loading ...
Loading ...