Loading ...
Loading ...
Loading ...
Initial Installation - for Power Supply Cord or Direct Wire Installations
Power Supply Cord Direct Wire
Fire Hazard
Use a new UL listed 30 amp power supply cord,
Use a UL listed strain relief°
Disconnect power before making e_ectrica_ connections,
Connect neutral w}re (wh}te or center w}re) to center
terminal (silver)°
Ground wire (green or bare wire) must be connected to
green ground connector,
Connect remaining 2 supply wires to remaining
2 terminals (go_d)°
Securety tighten aH electrica_ connections,
Failure to do so can result in death, fire, or
electdca_ shock,
1. Disconnect power.
2. Remove the hold-down screw and terminal block cover.
D
/
Fire Hazard
Use 10 gauge solid copper wire,
Use a UL listed strain relief,
Disconnect power before making electdca_ connections.
Connect neutral wire (white or center wire) to center
termina_ (sHyer).
Ground wire (green or bare wire) must be connected to
green ground connector,
Connect remaining 2 supply wires to remaining
2 terminals (gold),
Securety tighten aH electrical connections,
Failure to do so can result in death, fire, or
eiectrica_ shock,
3. Install strain relief.
Style 1: Power supply cord strain relief
• Remove the screws from a %" (1.9 cm) UL listed strain
relief (UL marking on strain relief). Put the tabs of the two
clamp sections into the hole below the terminal block
opening so that one tab is pointing up and the other is
pointing down, and hold in place. Tighten strain relief
screws just enough to hold the two clamp sections
together,
L .......................................................... A
C
A. Neutral grounding wire (green with yellow stripes)
B. External ground conductor screw
C. Center, silver-colored terminal block screw
D. Terminal block cover and hold-down screw
A. Strain relief tab
B. Hole below terminal block opening
C. Clamp section
Loading ...
Loading ...
Loading ...