Loading ...
Loading ...
Loading ...
THERMOSTAT OPERATION
FAN
When the power is connected, the LCD screen on the thermostat will illuminate. Pressing
the FAN button once, will turn on the evaporator fan blower. To turn the blower off, push
the FAN button once again.
COOLING MODE Ä
To operate unit for cooling, push MODE button to display COOL in the window.
Push down arrow button multiple times to lower set point to desired temperature.
The display will show the set-point temperature for 5 seconds, then it will return to room
temperature display.
After a slight pause, the fan motor and compressor will start, beginning the cooling cycle.
Remember, the set-point must be lower than the room temperature for the unit to start.
The OUTDOOR and DAY/NIGHT buttons are not used and do not effect unit opera-
tion.
This is a cooling only thermostat. Select the temperature you want by pressing the ▲ or
▼ buttons. The word COOL and the temperature set-point is displayed for 5 seconds.
To change display to Celsius, simultaneously press the ▲ and ▼ buttons. Press them
again to change back to Fahrenheit.
No batteries are required. In the event of a power failure, when the power is restored the
thermostat will continue operating as if the power had never been off.
Compressor short cycle protection is built-in to the thermostat. A 4-minute time delay will
protect the unit.
MODE
FAN
OUTDOOR
DAY/NIGHT
72
WAIT 4 MINUTES
BEFORE RE-STARTING
COOL
15
Loading ...
Loading ...
Loading ...