Loading ...
Loading ...
Loading ...
9
4. Install the 6 mm nuts to the outside top or outside back
(alternate location on some models) of the range hood at the
proper location for the selected motor system.
■ Two 6 mm nuts are required for the single motor system.
Clip nuts into the small square notches located at the left
and right end of the square vent opening.
■ Five 6 mm nuts are required for the dual motor system.
Clip nuts into the small square notches, one located in
the front of the square vent opening and the other four
located at the left and right ends of the square vent
opening.
5. Mount range hood. See the “Install Range Hood” section.
Install Range Hood Internal Blower Motor
IMPORTANT: The blower has to be installed before installing the
hood to the wall.
1. Install the range hood blower motor assembly inside the
range hood with the wiring connection to the left for the
single motor system and to the front or top for the dual
motor system.
Single Blower Motor Assembly
Dual Blower Motor Assembly
2. Slide the left mounting plate ange under the motor
mounting bracket.
3. Run the power supply wires and connector from the range
hood through the hole in the right end of the motor mounting
plate.
4. Push the right end of the motor mounting plate up and snap
it into the spring tab.
NOTE: The spring tab should be outside the slot in the
mounting plate.
A
A
A
B
A. Wiring connection
A
A
A. Wiring connection
BA
A. Motor mounting bracket
B. Mounting plate left ange
A. Motor mounting plate
B. Power supply wires and connector
B
A
B
A
A. Motor mounting plate
B. Spring clip
A. Clip nut locations for dual motor assembly (5)
B. Clip nut locations for single motor assembly (2)
Loading ...
Loading ...
Loading ...