Loading ...
Loading ...
Loading ...
8
Complete Preparation
1. Determine and make all necessary cuts in the wall for the
vent system. Install the vent system before installing the
range hood. See the “Venting Requirements” section.
2. Determine the location where the power supply cable will be
run through the wall. Be sure that the location will be covered
by the chimney of the range hood.
3. Drill a 1
1
/
4
" (3.2 cm) hole at this location.
4. Pull enough power supply cable through the wall to allow for
easy connection to the terminal box.
NOTE: Your range hood requires you to purchase either
an internal type or an in-line (external type) blower motor
system.
For internal blower systems, there are blower motor
mounting parts in the blower motor installation packet that
must be added to the range hood prior to mounting the
range hood to the wall. See the “Install Range Hood Internal
Blower Motor” section and the instructions supplied with the
blower motor.
Install Range Hood
1. Using two or more people, hang range hood on two
mounting screws through the mounting slots on back of
range hood.
2. Level the range hood and tighten upper mounting screws.
3. Install two 5 x 45 mm lower mounting screws and tighten.
Install Range Hood Internal Blower
Motor
NOTE: Your range hood requires you to purchase either an
internal type or an in-line (external type) blower motor system.
Prepare the Internal Blower System
IMPORTANT: Perform steps 1-4 before mounting the range
hood.
1. Remove grease lters from range hood. See the “Range
Hood Care” section.
2. Install the motor support bracket using three
4.2 x 8 mm screws. Screw bracket to the inside top or back
(alternate location on some models), toward the left side of
the range hood.
3. Install motor spring clip using two 4.2 x 8 mm screws. Screw
spring clip to the inside top or back (alternate location on
some models) of the range hood at the proper location for
the selected motor system. Slide the mounting tab of the
spring clip through the slot in the panel and secure with the
screws. Use the inside set of mounting holes for the single
motor system. Use the outside set of mounting holes for the
dual motor system.
A
B
A. Mounting screws
B. Mounting slots
A
A. Lower-mounting screws
A. 4.2 x 8 mm screws (3) for motor support bracket
B. 4.2 x 8 mm screws (2) for motor spring clip
C. Motor support bracket
D. Motor spring clip (single motor assembly location)
E. Motor spring clip (dual motor assembly location)
A
C
D
E
B
Loading ...
Loading ...
Loading ...