Loading ...
Loading ...
Loading ...
Page 14
OPERATION
2. To remove the auxiliary handle, remove
the battery pack, then loosen the
auxiliary handle by turning the handle
counterclockwise.
WARNING:
For safety and ease of
operation, securely tighten the auxiliary
handle by turning the handle clockwise
before every use.
TO INSTALL/REMOVE THE
AIR-INLET FILTER (FIG. 7)
FIG. 7
Air-Inlet Filter
Notch
Using the air-inlet lter will improve the
performance and extend the life of the tool.
1. Remove the battery pack.
2. To install the lter, snap the lter onto the
tool’s foot.
3. To remove the lter, pry the lter away
from the notch with a nger.
4. To clean the lter, tap it against a hard
surface or blow it clean with compressed
air. Always wear safety goggles when
cleaning tools using compressed air.
WARNING:
Always wear safety
goggles or safety glasses with side
shields during power tool operation. If
operation is dusty, also wear a dust mask.
PADDLE SWITCH OPERATION
(FIG. 8)
FIG. 8
Paddle Switch Lock-Off Lever
The angle grinder/cut-off tool is equipped with
a paddle switch to turn the tool on and off.
1. To turn the tool ON, push the lock-off
lever forward and then squeeze the
paddle switch.
2. To turn it OFF, release the paddle switch
and allow it to return to the OFF position.
Make sure that the tool comes to a
complete stop before laying the tool down.
Loading ...
Loading ...
Loading ...