Loading ...
Loading ...
Loading ...
Page 11
OPERATION
TO ATTACH THE BATTERY PACK
(FIG.1)
FIG. 1
Detach
Attach
Battery-
Release Button
1. Make sure that the angle grinder is
turned off.
2. Align the raised rib on the battery pack
with the grooves on the bottom of the
tool, and then attach the battery pack to
the angle grinder.
3. Pull on the battery pack to make sure it
is securely latched to the tool.
TO DETACH THE BATTERY PACK
(FIG. 1)
1. Make sure that the angle grinder is
turned off.
2. Depress the battery-release button
located on the front of the battery pack
to release the battery pack.
3. Pull the battery pack forward to remove
it from the tool.
TO INSTALL/REMOVE THE
GRINDING GUARD (FIG. 2)
FIG. 2
Tabs
Adjusting
Screw
Guard Lever
This tool is shipped with two types of guards.
A dedicated guard must be used when using
the tool as a grinder or as a cut-off tool.
To Install the Guard:
1. Remove the battery pack and remove
any accessory from the spindle.
2. Open the guard lever to release the
guard.
3. Align the tabs on the guard with the slots
in the grinder gear-box collar and lower
the guard until the guard can rotate
freely in the groove in the collar.
4. Rotate the guard to a suitable position
so that the guard is positioned between
the spindle and the operator to provide
maximum operator protection.
5. Lock the guard in place by pulling the
guard lever.
WARNING:
Keep the guard
between you and the wheel. Do not direct
the guard opening toward your body.
To Remove the Guard:
1. Remove the battery pack and remove
any accessory from the spindle.
2. Open the guard lever to release the
guard.
3. Rotate the guard to the position where
the tabs on the guard align with the slots
in the gear-box collar.
4. Lift the guard straight up and remove it
from the tool.
Loading ...
Loading ...
Loading ...