Loading ...
Loading ...
Loading ...
Page 12
OPERATION
TO ADJUST THE GUARD (FIG. 2)
To adjust the guard, keep the guard lever
open, then rotate the guard to a suitable
position so that the guard is positioned
where it can provide maximum operator
protection, then close the lever to lock the
guard in place.
NOTICE: Use only grinding wheels of the
specified size with the grinding guard. Use
only cut-off wheels of the specified size
with the cutting guard.
NOTICE: The guard is pre-adjusted to
the diameter of the gear-box collar at the
factory. If, after a period of time, the guard
becomes loose, tighten the adjusting
screw in the guard with a Phillips-head
screwdriver (not included).
WARNING:
If the guard cannot
be tightened by adjusting the screw, do
not use the tool and take the tool and
the guard to a service center to repair or
replace the guard.
TO INSTALL/REMOVE THE CUT-
TING GUARD (FIG. 3)
FIG. 3
Grinding
Guard
Cutting
Guard
Hook
Hook
1. Remove the battery pack from the angle
grinder.
2. Use the cutting guard to cover the
grinding guard: position one hook of the
cutting guard to engage the grinding
guard, and then push the cutting guard
until the other hook fully engages with
the grinding guard.
3. To remove the cutting guard, use a
at-head screwdriver (not included)
to detach one hook from the grinding
guard, and then the cutting guard can be
pulled out easily.
WARNING:
A guard must be used
when using the tool as a grinder or cut-off
tool. To protect you from serious injury,
never use the grinder with the guard
removed.
WARNING:
Make sure that the
guard lever secures the guard before
operation. Do not direct the guard
opening towards your body.
TO INSTALL THE GRINDING OR
CUTTING WHEEL
(FIG. 4 OR FIG. 5)
FIG. 4
Lock
Nut
Grinding
Wheel
Backing
Flange
Grinding
Guard
Spindle
Spindle-Lock
Button
FIG. 5
Lock
Nut
Cutting
Wheel
Backing
Flange
Cutting
Guard
Spindle
Spindle-Lock
Button
Loading ...
Loading ...
Loading ...