Loading ...
Loading ...
Loading ...
EN - 6
5. CONTROLS
5.1 BLADE CONTROL LEVER
the blade (cutting device) to be operated.
• Model HT 20 Li A
Operating the cutting device is only possible if
• Modello HT 20 Li S
Operating the cutting device is only possible if
The cutting device stops automatically
when the lever is released.
5.2 BLADE CONTROL LOCKING
BUTTON
The blade control locking button
5.3 SAFETY SWITCH
be held down together with the blade control
lever in order to operate the cutting device.
The cutting device stops automatically
when the safety switch is released.
5.4 REAR HANDGRIP RELEASE
positions in relation to the cutting means to
The handgrip must only be adjusted
when the machine is switched o.
6. USING THE MACHINE
IMPORTANT The safety standards to be
followed are described in chapter. 2. Strictly
comply with these instructions to avoid
serious risks or dangers.
6.1 PRELIMINARY OPERATIONS
Place the machine in a stable
horizontal position on the ground.
6.1.1 Checking and recharging
the battery (Fig. 5)
Before each use check the battery
charge status according to the
instructions in the battery booklet.
6.2 SAFETY CHECKS
Always carry out the safety
checks before use.
6.2.1 General check
Object Result
Handgrips (Fig. 1.C,
Fig. 1.D) and guards
Screws on the
machine and blade
Correctly tightened
(not loose)
Cooling air ducts Not clogged
Blade (Fig. 1.B) Sharp, not damaged or
worn, well sharpened.
Guards Intact, undamaged.
Battery (Fig. 1.F) No damage to the casing,
no liquid leakage.
Machine No signs of damage
or wear. No abnormal
vibrations.
No abnormal sound.
Levers, buttons, and
safety switches
They must move freely,
not be forced and when
released they must return
automatically and rapidly
to the neutral position.
Loading ...
Loading ...
Loading ...