Loading ...
Loading ...
Loading ...
8
Connect Vent System
1. Install transition on top of hood (if removed for shipping)
with(2) 3.5 x 9.5 mm sheet metal screws.
A. Vent transition
B. 3.5 x 9.5 mm screw
A
B
For vented installations only:
1. Fit vent system over the exhaust outlet.
2. Seal connection with clamps.
3. Check that back draft dampers work properly.
Install Range Hood
NOTE: Remove protective lm from range hood and metal lters.
1. Using 2 or more people, hang range hood on 2 mounting
screws through the mounting slots on back of hood.
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
2. Remove the grease lter. See “Range Hood Care” section.
3. Level the range hood and tighten upper mounting screws.
4. Install (2) 5 x 45 mm lower mounting screws and tighten.
Usethe optional wall anchors if needed.
For non-vented (recirculating) installation only:
1. Assemble the air deector with the duct cover bracket
using(4) 4 x 8 mm screws.
2.
A
B
C
A. Assembly screws
B. Air deector
C. Duct cover bracket
Measure from the bottom of the air deector to the bottom
ofthe hood outlet.
X
A
C
D
B
E
A. Air deector
B. Vent clamp
C. X = length to cut vent duct
D. Vent duct
E. Exhaust outlet
3. Cut the duct to the measured size “X.”
4. Remove the air deector.
5. Slide the duct onto the bottom of the air deector.
6. Place the assembled air deector and duct over
theexhaustoutlet from the hood.
7. Reassemble the air deector to the duct cover
bracketwiththe 4 assembly screws.
8. Seal connections with vent clamps.
Loading ...
Loading ...
Loading ...