Loading ...
Loading ...
Loading ...
7
1
4
1
2
3
Installation Guide
The appliance is very heavy.
Take maximum care during handling to
avoid injury.
The appliance should always be transport-
ed in an erect position.
Avoid at all costs leaning it on its front side.
Preparing the installation
Transport to installation site
and unpacking
Since this is a large and heavy appliance, before transporting the ap-
pliance, check the access to the location where it will be installed
(door size, manoeuvring space in stairwells, etc.).
The appliance is attached to the base of the packaging (pallet) through
four bolts which can be removed using a 17 mm (3/4”) wrench.
It is recommended to use a manual transporting device to move the
appliance to the installation site, and only at this point to remove the
base of the packaging.
The appliance should always be transported in an erect position.
If this is not possible, transport the appliance laying on its rear side.
Once at the installation site, the appliance, which is equipped with four
wheels, can be taken off the pallet and positioned in the installation
area.
Operate as follows:
Take off the four bolts
1
securing the appliance to the pallet by
means of a 17 mm (3/4”) open spanner.
Remove the xing brackets
3
and
4
.
To remove the front xing bracket
3
, unscrew for one or two
turns the rear wheel adjusting bolt
2
by means of a 13 mm (1/2”)
box spanner, avoiding too much strenght while thightening the
nut, which could damage the leveling feet adjusting system.
From the back of the unit and by means of a suitable, high duty hand
trolley, take off the appliance and place it on the oor.
Be very careful to avoid any damage to oors. Delicate oors should be
protected with plywood, hard cardboard or similar material panels.
Series: All
Loading ...
Loading ...
Loading ...