Asko HC1643G 60cm Ceramic Electric Cooktop

Operating Instructions - Page 22

For HC1643G. Also, The document are for others Asko models: SVK67CS

PDF File Manual, 32 pages, Read Online | Download pdf file

HC1643G photo
Loading ...
Loading ...
Loading ...
EN 22
Important warnings
Installation of the appliance into a kitchen worktop and its
connection to the power mains may only be performed by an
adequately qualified technician.
Veneer or other finish of the piece of kitchen furniture into which
the hob is to be built in should be treated with heat resistant
glue (100°C); otherwise, the worktop finish may be discolored or
deformed.
Cooking hob is dimensioned to be built into the worktop over a
piece of kitchen furniture, with a width of 600 mm or more.
Hanging, or wall-mounted kitchen elements should be installed
high enough not to interfere with the work process.
The distance between the cooking hob and the kitchen hood
should be no less than indicated in the instructions for kitchen
hood installation. The minimum distance is 650 mm.
The distance between the appliance edge and the adjacent tall
kitchen furniture element should amount to no less than 40 mm.
Use of massive wood decoration plates or boards on the
worktops behind the cooking hob is permitted, if the minimum
distance remains.
Minimum distance between the built-in cooking hob and the rear
wall is indicated on the installation drawing.
Given the protection from the risk of fire, appliances of this type
may be installed in a worktop next to a piece of kitchen furniture
that is taller than the appliance (when installed); however, in this
case, a kitchen furniture not higher than the cooking hob must be
installed on the other side, adjacent to the appliance.
Attention
Before any manipulation with the appliance (other than its regular
use), disconnect it from the power mains. The appliance should
be connected according to the relevant scheme (diagram),
subject to the network voltage. Connect the earth (PE) wire to the
clip indicated with the earth /ground symbol.
The mains cord must be fed through the fastening clip /
strain release device which protects it from being pulled out
accidentally.
After connecting the appliance, turn on all cookers for
approximately three minutes to check their operation.
INSTALLATION
Loading ...
Loading ...
Loading ...