Loading ...
Loading ...
3 4
System Connection:
Caution:
1.Correctly place the batteries inside the battery
box of the remote.
2.The maximum reception distance between the
remote and the unit is about 7m.
3.The maximum effective angle of the remote
aligning at the reception window is 30°.
Please Note:
1. When the unit is moved, please use the original
paper box and packing materials and the factory
packing method to optimally protect the unit.
2. Do not place volatile liquids beside the unit, and
do not allow rubber or plastic to make contact with
the unit for extended periods of time as these
products may mark the surface of the unit.
3. After the unit has been in use for a lengthy period
of time, it may heat up on top and at the rear plate.
This is normal.
4. When the unit is not used, please take out the
disc, close the disc door and turn the power off.
5. If you have not used the unit for a long time and
nd that certain function keys are not working,
please refer the unit to qualied service
personnel for maintenance.
Location :
When your unit is placed near the TV, radio or video
tape recorder, poor image quality and sound
distortion may occur. In that case, please relocate
the unit away from such equipment.
Cleaning:
1. Use a soft cloth to clean the unit.
2. Please use the cloth with a small amount of
diluted cleaning agent to deal with dirty spots
which are not easily cleaned. Do not use any
solvents with corrosive substances like diluted,
gasoline solvent, abrasive solution, etc. which will
damage the surface of the unit.
Warning: The cleaning and adjustment of internal
parts should be conducted by trained authorised
personnel.
1. How to take care of your discs: Do not touch the
playing side of the disc.
2. How to clean your discs: Use a soft cloth to wipe
the disc from the centre out.Fingerprints and dust
remaining on the disc will affect the quality of the
image and sound. When cleaning stubborn dirt,
use a clean soft cloth dipped into a little water to
wipe the disc, then use a dry soft cloth to dry it.
Do not use solutions like methylbenzene,
cleaning agents or antistatic spray to clean the
disc.
3. How to store your discs: Do not place the discs in
a place with heavy moisture, dust or direct
sunlight. When the discs are not used, please
place them in their boxes.
Batteries:
Using the batteries incorrectly will cause leakage
or corrosion of the battery uid. Please use the
batteries in accordance with the following
instructions:
1. Do not reverse the positive and negative
polarity when the batteries are inserted.
2. Do not recharge non-rechargeable batteries,
disassemble the batteries, make them short
circuit or throw them into a re.
3. Do not mix different types of batteries or old and
new batteries .
4. Do not keep damaged batteries in the remote.
5. If the remote is not used for a long time, please
remove the batteries to avoid damage caused by
the leaking of the battery uid.
6. If the remote is faulty or its effective scope is
reduced, please replace with new batteries.
7. If the batteries have leaked battery uid, please
dry the battery box and replace with new batteries.
Remote Control:
Using the remote incorrectly will result in poor
performance. Please use the remote in accordance
with the following instructions:
1. The emitter of the remote should not be exposed
to sunlight.
2. Please aim the remote at the reception window of
the unit.
3. Do not drop the remote as it may get damaged.
4. Do not allow water or any other liquids to come
into contact with the remote.
5. Do not disassemble the remote.
Tips:
VID EO IN
TV
(Yellow)
(Yellow)
Video Connecting Wire
cr
cb
y
TV
(cb)
(Green)
(Y/CR/CB Terminal)
(Yellow)(Yellow)
(Red) (Red) (Red)
(White) (White)
Please note: The component output terminals Y/g C/b C/r are the same as Y, U, and V.
TV
R
L
(Red)
(Red)
TV Audio Terminal
(White)
(White)
Please note:
1. When connecting speakers, please make sure the
right and left speakers are connected
correctly to the terminals. Do not short circuit the
connections as this will cause damage to the system.
2. To connect correctly, connect red wire to “+” and
black wire to “_”.
Surround Right Speaker Surround Left Speaker
Surround Speaker Connecting Guide:
Caution: Always disconnect the unit from the power when making or changing any connections to avoid
risk of electric shock.
Please note: An AV cable is included as an accessory. This can be used to make any ONE of the
following connections.
Video Connection:
Choose one of the following two methods to connect to the TV.
1. Composite Video Connection
2. Component (YCbCr) Connection
Please note: If you use this option for video connection, you will need an extra stereo RCA cable for the
audio connection (see below).
Audio Connection:
Connect to the L-R Audio output of the TV.
Please note: If using YCbCr connection (see above) for video, you will need an additional cable for
this audio connection.
The component output terminals provide Y,U,V or Y,Pb,Pr to correspond with the Y,U,V or Y,Pb,
Pr input of the TV. The image quality of component output is better than AV output (in the Setup Menu,
set Video Output to Y,U,V or Y,Pb,Pr according to the TV inputs, otherwise the image may not be
displayed).
Discs:
Loading ...
Loading ...
Loading ...