Loading ...
Loading ...
Loading ...
Display
Rinse Plus Option ( )
9
This option is recommended for
people who are allergic to
detergents, and in areas where the
water is very soft.
To deactivate press
and hold
these 2 touchpads at the same
time
until the LED “ ” goes off.
Start/Pause Touchpad ( )
To start the selected program,
press the “Start/Pause”.
To interrupt a program which is
running, press the “Start/Pause” to
pause the machine, t
he Start/Pause
pilot light flashes.
To restart the program from the
point at which it was interrupted,
press the “Start/Pause” again,
the
Start/Pause pilot light will stop
flashing
.
The display shows the following
information:
Child Lock Option ( )
Your appliance is provided with
CHILD SAFETY LOCK which
permits you to leave the appliance
unsupervised with the door closed
without having to worry that
children might be injured by or
cause damage to the appliance.
Set this option after pressing the
Start/Pause touchpad.
This function remains
enabled even after the
appliance is switched off.
Press and hold “ ” and “ ”
touchpads at the same time
until the LED “ ”
lights up
.
The touchpads are locked
(except for the On/Off
“ ” button).
To set “Child Lock” option:
When the program is
completed the display
will show “ ”.
Incorrect Option Selection
If an option which is
not compatible with
the set wash
program selected, the display will
show “ ” and flash with 3
consecutive short beeps.
End Of Program
In the event of
operating problems,
some alarm codes
can be displayed, for example .
(See “Troubleshooting”.)
Alarm Codes
Estimated time of the selected
program
After selecting a
program, the
estimated time is
The estimated time is calculated
automatically on the basis of the
maximum recommended load for
each type of fabric. After the
program has started, the time
remaining is updated every minute.
displayed in hours and minutes (for
example 3.01).
If you wish to modify or cancel Delay
End option after starting the
program, follow the steps below:
set the washing machine to
PAUSE by pressing “Start/Pause”
touchpad;
-
deselect this option by pressing
Delay End once;
-
press the “Start/Pause” to start
the program.
-
7
8
9
10
Loading ...
Loading ...
Loading ...