Loading ...
Loading ...
Loading ...
EN
Instructions for the User
23
The timer stops and the display shows the remaining amount of
operating time.
If you wish, at this time you can:
Turn or stir the food to ensure it will be evenly cooked.
Modify the process parameters.
Cancel a cooking cycle
End of a cooking cycle.
To restart the process, close the door and press PT2.
8.2.2 Modifying parameters
The operating parameters (time, temperature, etc.) can only be modified
when the cooking process has been interrupted. Proceed as follows:
Press PT1 to activate the parameter modification mode. The
symbol starts to blink. Turn PT1 to the right or left to
change the remaining cooking duration.
Press PT1 to validate and the next parameter light starts to
blink. Proceed as described in the active function chapter to
modify the remaining parameters.
Press PT2 to continue the cooking process.
8.2.3 Cancelling a cooking cycle
If you wish to cancel the cooking process, press PT2 for 3 seconds.
You will then hear a beep and the oven will be in the condition described
in the following paragraph.
8.2.4 End of a cooking cycle
At the end of the set duration or when you press PT2 to finish the cooking
cycle, you will hear three beeps and the display will show the word “End”
flashing, the oven starts the steam-reduction function.
This function gradually releases the steam from the cavity, so that there is
no sudden rush of steam when the appliance door is opened.
This function takes around 3 minutes and during it the display shows the
word “VAP”. If you want to start a new cooking cycle press PT2 and rotate.
WARNING! WHEN OPENING THE DOOR DURING OR COMPLETION
OF THE COOKING CYCLE WITHOUT STOPPING IT AS DESCRIBED,
BE CAREFUL OF THE FLOW OF HOT AIR AND/OR STEAM COMING
OUT OF THE COOKING CHAMBER. STEP BACK OR TO THE SIDE TO
AVOID BURNS.
The cooling fan can continue to run for a certain length of time after
the appliance has been switched off. This is a normal function that is
meant to reduce the temperature inside the oven.
In the meantime, as soon as the water in the boiler reaches below 75 ºC it
is pumped back to the water tank. This phase can take as long as 10
minutes and the DSP1 shows the message “PUMP”. If the display shows
“FULL” it means that the water has to match water inside. Please empty
the tank and place it again.
When the display shows the word “DEP”, this means that the water was
pumped and that the water tank can be removed.
Loading ...
Loading ...
Loading ...