Loading ...
Loading ...
Loading ...
Owner’s Guide & Installation Instructions
63 / English
Troubleshooting
Problem Reason Solution
Product vibrates
or makes noise.
Product might be standing
unbalanced.
* Stablize the product by
adjusting the feet.
A hard substance might have
entered into the pump filter.
* Clean the pump filter.
Transportation safety bolts are
not removed.
* Remove the transportation
safety bolts.
Laundry quantity in the
product might be too little.
* Add more laundry to the
product.
Excessive laundry might be
loaded in the product.
* Take out some of the laundry
from the product or distribute
the load by hand to balance
it evenly in the product.
Product might be leaning on a
rigid item.
* Make sure that the product is
not leaning on anything.
There is water
leaking from the
bottom of the
washer.
Inlet hose connections may be
leaking.
* Be sure the strainers and
rubber seals of the water
inlet hoses are solid and
securely fitted.
End of the drain hose may be
loosely inserted into the waste
pipe or sink.
* Tightly attach the drain hose
to the waste pipe or sink
(See “Installation Instructions,
Drainage”).
House drain may be clogged.
* If the house drain pipes are
clogged, call a plumber for
assistance.
Filter cap of the drain pump
may not be properly fitted.
* Make sure that the pump
filter cap is tightly closed.
Hose connections inside the
washer may be leaking.
* Internal hose connections
(e.g. dispenser hoses, drain
system) should be checked
by a service technician.
Product stopped
shortly after
the programme
started.
The machine might have
stopped temporarily due to
low voltage.
* Product will resume running
when the voltage is restored
to a normal level.
Product directly
discharges the
water it takes in.
Draining hose might not be at
an adequate height.
* Connect the water draining
hose as described in the
operation manual.
No water can be
seen in the drum
during washing.
Water is inside the invisible
part of the product.
* This is not a failure.
Loading ...
Loading ...
Loading ...