Loading ...
Loading ...
Loading ...
EN 14
USING THE OVEN
9 AUTOMATIC OVEN CLEANING ONLY IN SOME MODELS
The automatic cleaning function, where present, may vary according to which model is purchased.
PYRO CLEANING CYCLE
IF PRESENT
For the description of this function, see also the
functions table on page 18 and the chapter
“Cleaning” on page 24.
Access special functions
.
Turn
to select .
Press to conrm.
Turn
to select desired pre-set duration.
Press to run Pyro cleaning cycle or press to
go to set end time (section 6).
Turn
to set the desired end time.
Press
to start automatic oven cleaning.
NOTE: during a Pyro-cleaning cycle, the oven door is
automatically locked.
Once the icon disappears, the oven is once again
fully functional.
WARNING
- Do not touch the oven during the pyrolysis
cycle.
- Keep children away from the oven during the
pyrolysis cycle.
- Keep animals away during and after the
pyrolysis cycle.
SMARTCLEAN
TM
CLEANING CYCLE
IF PRESENT
For the description of this function see also the
functions table on page 18.
With the oven cold, distribute 200 ml of water on
the bottom of the oven cavity, then close the oven
door.
Access special functions
.
Turn
to select .
Press
to conrm.
Press to start immediately SMARTCLEAN
TM
cycle or press
to set end time/start delayed (see
section 6).
At the end of the cycle, remove any residual water
in the oven and start cleaning using a sponge
moistened with hot water (cleaning could be
compromised if delayed by more than 15 minutes).
To eliminate particularly stubborn grime, repeat
the SMARTCLEAN
TM
cycle and add a few drops of
neutral detergent while removing the grime.
NOTE: a smaller or greater amount of water could
compromise proper functioning of the cleaning cycle.
The duration of cleaning cycle cannot be set.
Loading ...
Loading ...
Loading ...