Loading ...
Loading ...
Loading ...
8
Customer Service Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
Customer Service Troubleshooting Tips
Installation Instructions
Safety Instructions
Operating Instructions
Customer Service Troubleshooting Tips
Installation Instructions
Safety Instructions
Operating Instructions
How to use the Operation Mode Selection button.
Auto Operation
Press the Start/Stop button. The unit will respond with a beep.
Open the door on the remote control. To select auto operation, press the Operation Mode Selection
button. Each time the button is pressed, the operation mode is shifted in the arrow direction.
2
1
The temperature and fan speed are
automatically set by the electronic controls
based on the actual room temperature. If you
want to change the set temperature, close the
door on the remote control and press the Room
Temperature Setting buttons. The cooler or
warmer you feel, the more times (up to two
times) you should press the button. The set
temperature will then be changed automatically.
During Auto Operation:
■ You cannot switch the indoor fan speed. It has
already been set by the electronic control.
■ If the system is not operating as desired,
manually switch to another mode. The system
will not automatically switch from the cooling
mode to the heating mode, or from heating to
cooling, it must be done manually. Reset using
the Operation Mode Selection button.
■ During Auto Operation, pressing the Airflow
Direction Start/Stop button makes the horizontal
louvers swing up and down automatically. If you
want to stop auto-swing, press the Airflow
Direction Start/Stop button again.
3
To raise the
temperature
To lower the temperature
Cooling
Auto Dehumidify
Heating (Heat pump only)
Press the Start/Stop button. The unit will respond with a beep.
Open the door on the remote control. To select dehumidify operation, press the Operation Mode
Selection button. Each time the button is pressed, the operation mode is shifted in the arrow direction.
2
1
Cooling Auto
Dehumidify Heating (Heat pump only)
Close the door on the remote control. Set the
temperature higher than the room
temperature. The temperature can be set within
a range of 64° F–86° F in 2° F increments.
During Dehumidify Operation:
■ The indoor fan speed is automatically set to low
and cannot be adjusted.
■ The indoor fan may stop during this operation if
the electronic control detects over-cooling.
3
Dehumidify Operation
To raise the
temperature
To lower the temperature
Loading ...
Loading ...
Loading ...