Loading ...
Loading ...
Loading ...
45
7
Appendix
MOVING INSTRUCTIONS
When moving this copier, follow the procedure below.
When moving this copier, be sure to remove the TD cartridge from the machine.
This prevents toner from spilling inside the machine during shipment.
1
Turn the power switch off and disconnect the power cord.
2
Remove the printer interface cable. (AL-840 only)
3
Push gently on both sides of the front cover to open the cover.
4
Gently pull the TD cartridge out. See page 28, TD CARTRIDGE REPLACEMENT.
5
Remove the copy paper from the paper tray. To remove the paper, see page 34,
Misfeed in the paper tray.
6
Remove the paper tray from the copier.
7
Gently push the paper output tray back into the copier until it stops.
8
Attach to the left side of the copier the screw that has been saved. See page 11,
REMOVING PROTECTIVE PACKING MATERIALS.
When shipping the copier, the screw must be reinstalled to prevent shipping
damage. This screw will secure the scanning head. If the power has been
turned off while an original was being scanned, the scanning head is not at the
left end position. In this case, turn on the copier and then turn it off after checking
to ensure that the head is at the left end position.
9
Close the front cover.
10
Attach the packing materials and tape which were removed during installation of the
copier. See page 11, REMOVING PROTECTIVE PACKING MATERIALS.
11
Pack the copier into the carton. See page 10, CHECKING PACKED COMPONENTS
AND ACCESSORIES.
Loading ...
Loading ...
Loading ...