Loading ...
Loading ...
Loading ...
en Water softening system/special salt
22
Adjusting the water softening
system
The amount of salt dispensed can be
set from 0 to 62°E. No salt is needed
with the setting 0-8.
Set the water softening system as
follows:
1. Ask your local water utility company
for the water hardness value of the
tap water.
2. Required setting can be found in the
water hardness table.
3. Switch on ON/OFF switch (.
4. Press and hold the Info button {
h for 3 seconds until the following
text appears on the front display
)B:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
5. Press the > )2 button repeatedly
until Water hardness appears on the
front display )B.
6. Adjust the setting using the setting
buttons + and - P.
7. Press and hold the Info button {
h for 3 seconds.
The chosen setting has now been
stored in your dishwasher.
Using special salt
As soon as the low salt indicator @ is
lit on the control panel or is requested
on the front display * )B, salt should
be topped up. Always refill with special
salt immediately before switching on the
appliance. This ensures that overrun
special salt solution is immediately
washed out and does not corrode
the rinsing tank.
Caution!
Detergent will destroy the water
softening system! Never pour detergent
into the salt dispenser.
Top up the salt as follows:
1. Undo the screw plug on the
dispenser 1b.
2. Fill the dispenser with water
(required only when switching on the
appliance for the first time).
3. Add salt as illustrated (do not use
table salt or tablets).
The water is displaced and runs out.
* depending on the features of your
dishwasher
*
Loading ...
Loading ...
Loading ...