Loading ...
Loading ...
Loading ...
Image Projection
▼Keycode input box
-34
Lamp
indicator
Power
indicator
INPUT
button
',", \, |
buttons
MENU
button
ENTER
button
ON button
', ", \, |
buttons
MENU button
ENTER
button
Basic Procedure
Connect the required external equipment to the pro-
jector before operating the following procedures.
Info
•
The language preset at the factory is English.
If you want to change the on-screen display
to another language, reset the language ac-
cording to the procedure on page
36
.
1 Plug the power cord into the
wall outlet.
• The power indicator illuminates red, and
the projector enters the standby mode.
2 Press
ON
on the projector or on
the remote control.
• The power indicator illuminates green.
After the lamp indicator illuminates, the
projector is ready to start operation.
Note
• The lamp indicator illuminates, indi-
cating the status of the lamp.
Green: The lamp is on.
Green blinking: The lamp is
warming up or
shutting down.
Red:
The lamp should be replaced.
• If the projector is put into the standby
mode and immediately turned on
again, the lamp indicator may take
time to illuminate.
• When controlling the projector using
RS-232C commands from a com-
puter, wait for at least 40 seconds
after the power has been turned on,
and then transmit the commands.
When “Anti-Theft” (see page 75) is
set, the keycode input box will appear.
• Enter the keycode.
Note
• When entering the keycode, press
the buttons previously set on the
projector or the remote control.
Info
•
When “Anti-Theft” is set, enter the
keycode or the input display will not ap-
pear. Even when the signal is input, the
display will not appear. (see page 75.)
ON button
Loading ...
Loading ...
Loading ...