Loading ...
Loading ...
Loading ...
MULTIMEDIA 327
ParkView Backup Camera Active
Guidelines
On Off
NOTE:
Your vehicle may be equipped with the “ParkView Backup Camera Active Guidelines” that allows you to see active guidelines over the ParkView
Backup camera display whenever the gear selector is put into REVERSE. The image will be displayed on the radio touchscreen display along with a
caution note to “check entire surroundings” across the top of the screen. After five seconds, this note disappears.
ParkView Backup Camera Delay On Off
NOTE:
When the vehicle is shifted out of REVERSE (with camera delay turned off), the rear camera mode is exited and the navigation or audio screen appears
again. When the vehicle is shifted out of REVERSE (with camera delay turned on), the rear view image with dynamic grid lines will be displayed for up
to 10 seconds after shifting out of “REVERSE” unless the forward vehicle speed exceeds 8 mph (13 km/h), the transmission is shifted into PARK or
the ignition is switched to the OFF position. To set the ParkView Backup Camera Delay press the Controls button on the touchscreen, the Settings
button on the touchscreen, then the Safety & Assistance button on the touchscreen.
Blind Spot Alert — If Equipped Off Lights Lights & Chime
NOTE:
When the feature “Blind Spot Alert” is selected, the Blind Spot Alert feature provides alerts, visual and/or audible, to indicate objects in your blind
spot. The Blind Spot Alert feature can be activated in “Lights” mode. When this mode is selected, the Blind Spot Monitor (BSM) system is activated
and only shows a visual alert in the exterior mirrors. When “Lights & Chime” mode is activated, the BSM shows a visual alert in the exterior mirrors
as well as sounds an audible alert when the turn signal is on. When “Off” is selected, the BSM system is deactivated.
If your vehicle has experienced any damage in the area where the sensor is located, even if the fascia is not damaged, the sensor may have become
misaligned. Take your vehicle to an authorized dealer to verify sensor alignment. Having a sensor that is misaligned results in the BSM not operating
to specification.
Setting Name Selectable Options
9
20_LD_OM_EN_USC_t.book Page 327
Loading ...
Loading ...
Loading ...