User Manual Thermador HMCB36WS 36-Inch Masterpiece Pyramid Chimney Wall Hood

• User Manual - (English, French, Spanish)

• Product Spec Sheet - (English)
• HC Home Connect leaflet - (English)
• Home Connect Leaflet - (English)

• Installation instructions - (English)

Use and Care Guide Masterpiece® Chimney Wall Hoods Thermador HMCB36WS

Table of Contents 

• Safety
• Important Safety Instructions
• Introduction
• Operating the Appliance
• Touch Control Panel
• Operating the Hood
• Home Connect
• Care and Cleaning
• Grease Filters Cleaning
• Cleaning Chart
• Hood Surface Cleaning
• Service
• Before Calling Service
• How to Obtain Service or Parts
• Product Data Rating Label
• Service Information
• Statement of Limited Product Warranty
• Service, Parts & Accessories

Care and Cleaning

Grease Filters Cleaning

• Your hood has removable aluminum mesh filters. They must be cleaned when the FILTER light illuminates on the touch panel or whenever they collect grease. When used over a grill, wok or other high grease applications, more frequent cleaning may be required.
• The filters may be washed by hand or in the dishwasher. Soak the ventilation filters in hot water using a mild detergent. Rinse well and shake to dry.
• Slight discoloration can occur when cleaning the filters in a dishwasher. This has no influence on the function of the grease filters.

Troubleshooting

Noise during operation: Some noise is normal due to vibration and air movement. Excessive noise could indicate one of the following:

1. Ductwork is too small / undersized
2. Ductwork is too large / oversized
3. Ductwork is loose
4. Transition is too small or is loose
5. Wood screws are not fully tightened
6. Loose screws in trim parts, etc.

Check Installation Manual to verify that ductwork is the proper size. Tighten screws.

Noise when unit is off  

• Backflow flap on outside of duct wall cap moves with the wind. This is normal.

Lights and fan blower do not work

• Hood circuit breaker may be tripped. Reset breaker.

Fan blower does not work

• Power supply is insufficient.
• Electrical wiring is incorrectly connected.